# Command Shaping

Within the basic command syntax, certain manipulations are available to ease readability and/or entry of commands.

Abbreviation

Commands may be shortened to their first few letters. In this documentation, the underlined characters in a command signature (see zone list, for instance) indicate the minimum necessary characters to type for correct recognition of the command. Note that a hyphenated command will require the minimum characters and the hyphen (e.g., zone apply-remove may be shortened to z a-r).

Continuation

There is no limit to the length of a command; a single command may contain any number of characters in a single line. However, in practice it is desirable to use multiple lines to break up long commands. An ampersand (&) or an ellipsis (...) can be given at the end of an input line to denote that the next line will be a continuation of that line. Both are valid and interchangeable. Note blank spaces are ignored (see “Delimiters” below).

zone create brick size 20 1 20 point 0 (3.0,0.0,0.0) ...
point 1 (20.0,0.0,0.0) &
point 3 (3.0,0.0,10.0) ...
ratio 1.08 1.0 0.97


Values

Many keywords are followed by a value or series of values that provide the input required by the keyword (this could be numeric, boolean, string, vector, or other input, including the name of a FISH function).

For numeric input, the decimal point may be omitted from a required real value, but may not appear in an integer value.

See the topic Command and FISH Highlighting in the Program and Command and FISH Reference Notation in the Documents as well for a guide to the appearance of commands in the program and in this documentation, respectively.

Delimiters

Commands, keywords, and numeric values may be separated by any number of spaces, or by any of the following delimiters:

( ) , =