geometry tessellate
command
Syntax
 geometry tessellate keyword ... <range>

Tessellate nodes. The nodes are tessellated in the current geometry set using the Qhull (http://www.qhull.org) package. Polygons are created in the current set, by default. See the toset and startset keywords to output polygons to different geometry sets. If the set keyword is not given, then the current set is used.
 convexhull
Calculate the convex hull of the nodes in the current geometry set. This keyword is not compatible with the startset.
 delaunay
Calculate the Delaunay simplices of the nodes of the current geometry set.
 set s
Specify the geometry set.
 startset s
Each Delaunay simplex or Voronoi region is placed in a unique set. Each set name is a combination of s with the ID of the set postpended to s. For example, the set with ID = 13 with s = con would have name con13. This keyword cannot be used with the convexhull keyword.
 toset s
Place the resulting polygons in the set with name s. This set is created if it does not exist.
 voronoi
Calculate the Voronoi regions of the nodes in the current geometry set.
Note
Voronoi regions with points at infinity are skipped when producing the output.
Was this helpful? ...  PFC © 2021, Itasca  Updated: Oct 01, 2021 