# rblock select command

Syntax

rblock select <keyword> <range>

Primary keywords:

This commands selects or de-selects all rigid blocks in the range. Selected objects can be specified in a range filter by using the selected keyword. Objects that are not selected can be specified in a range filter by using the deselected keyword.

The following keywords are available:

b

If a boolean type is specified, then if on it selects all rigid blocks in the range. If off it de-selects all rigid blocks in the range. on is the default if no keyword is given.

new

Implies on. This will select rigid blocks in the range, and automatically de-select rigid blocks not in the range.

undo

This will reverse the operation of the last rblock select command. A maximum undo stack of size 12 is retained.