block face apply-remove
command
Syntax
- block face apply-remove keyword <range>
Primary keywords:
load load-x load-y load-z stress convection flux westergaard
Remove an applied boundary condition for objects in the given range.
- load
Remove load boundary conditions in the x-, y-, and z-directions.
- load-x
Remove boundary condition in the x-direction.
- load-y
Remove boundary condition in the y-direction.
- load-z
Remove boundary condition in the z-direction.
- stress
Remove stress boundary condition.
- convection
Remove a convective boundary.
- flux
Remove a flux boundary.
- westergaard
Remove any previously defined added masses.
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |