flowplane edge apply
command
Syntax
- flowplane edge apply keyword ... <range>
Set boundary conditions along flow plane edges.
- discharge f <proppant f > <[flowedgeapplyblock]>
Set discharge boundary condition. Discharge is per unit length of a joint trace on the boundary surface. The specified discharge is cumulative, so the discharge specified is added to the existing discharge boundary condition. An optional proppant volume concentration may be specified for the injected fluid using the proppant keyword.
- flux f <[flowedgeapplyblock]>
Set heat-flux boundary conditions for convection on flow pipes in the range.
flowplane edge apply
Keyword Block
The keywords below are applicable to each of the following keywords of the flowplane edge apply
command:
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |