Z Position

Interactive Use

Set Filter: Position the mouse over one of the two handle points ( pos_handl ) until it indicates that positioning mode is ready ( cur_posit ). Left-click and drag to set the position of the plane.


Not: Invert the filter element’s selection.

Extent: If checked, only include the item if its entire extent fits within this filter element’s definition. If not checked, the item’s centroid is used to determine the location of the item and whether it is within the filter element’s definition.

Low: Specify the lower bound of the filter element.

High: Specify the upper bound of the filter element.

Center: Specify the center of the filter element.

Tolerance: Specify the distance from the center (in both directions) to extend the filter element.