geometry polygon group
command
Syntax
 geometry polygon group s <keyword ...> <range>

Assign the group s to the polygons of the geometric set that fall within the range. Use of the group logic is described in Groups. This command may take the form
geometry polygon group
"slotname = groupname" — quotation marks required, spaces at equals sign ignored — where slotname is the slot assignment and groupname is the group name. If the set keyword is not given, then the current set is used. remove
Remove s from all polygons. If no slot was specified, then the group will be removed from all slots it is found in.
 set s
Specify the geometry set.
Was this helpful? ...  FLAC3D © 2019, Itasca  Updated: Feb 25, 2024 