geometry rotate
command
Syntax
- geometry rotate keyword ... <range>
-
Rotate nodes. The optional range is applied to nodes, and they are rotated via the right-hand rule about a specified axis that passes through a specified point. If the set keyword is not given, then the current set is used.
- angle f
Angle of rotation in degrees.
- axis v
Axis of rotation about which to rotate following the right-hand rule.
- origin v
Point to rotate about.
- set s
Specify the geometry set.
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |