program log-file
command
Syntax
- program log-file s
Specify the log file by name.
Note
As with all program commands, use of the command word program is optional; program log-file and log-file are both valid.
Logging must be activated with the
program log
on command [DR: check previous commmand is correct] to activate writing. If logging is active and the program.log-file command is given, then the previous log file (if any) is closed and the new file s is opened.
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |