zone apply-remove
command
Syntax
- zone apply-remove <keyword> <range>
-
Remove a zone condition. Zone conditions are applied using the
zone apply
command. If no keyword is supplied, all conditions are removed on each zone in the range. If no range is supplied, the condition is removed from all zones. To remove conditions applied to zone faces, see the commandzone face apply
.- force
Remove a
zone apply force
(vector) condition applied to a zone.
- force-x
Remove a
zone apply force-x
condition applied to a zone.
- force-y
Remove a
zone apply force-y
condition applied to a zone.
- force-z
Remove a
zone apply force-z
condition applied to a zone.
- source
Remove the heat-generating source applied as a volume source of specific strength to a zone (i.e., remove a
zone apply source
condition).
- well
Remove the volume rate of flow applied to each zone (i.e., remove a
zone apply well
condition).
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |