`zone property-distribution`

command

Syntax

- zone property-distribution <[property] fvalue > keyword ... <range>
Primary keywords:

deviation-gaussian deviation-uniform gradient add multiply vary

Modify a zone constitutive model property. The property should accept a value of type float. While technically any valid type can be used here, none of the distribution keywords will apply and the

`zone property`

command should probably be used instead.The phrase that modifies the value must be given immediately following the property value. For more information on modifying values and the operation of these keywords, see the Value Modifiers topic.

The special density keyword can be given as a property as well, assigning density to zones; this is not a constitutive model property but stored within the zone class.

- deviation-gaussian f
A Gaussian distribution is used to assign the property values randomly, with a mean of fvalue and standard deviation of f .

- deviation-uniform f
A uniform distribution is used to assign the property values randomly, with a mean value of fvalue and a standard deviation of f.

- vary v
Apply a linear variation to the property value.

Usage Example

The following example illustrates how `zone property-distribution`

can be used

```
zone property-distribution cohesion 600 deviation-gaussian 10
```

The above example is to input Gaussian distribution of cohesion with a mean of 600 and standard deviation of 10.

Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |