clump group
command
Syntax
- clump group s keyword ... <pebble> <range>
-
Specify clump or pebble group names. Use of the group logic is described in Groups. By default, s is assigned to the group slot Default. Use the any keyword to assign the group name to the next available slot and the remove keyword to remove s from all slots. The optional pebble keyword can be given before the optional range to specify that the group name will be applied to pebbles. In this case, the range is applied to pebbles and not to clumps.
- add
Assign s to the next available slot.
- remove
Remove s from all slots.
Usage Examples
Assign the group outer
to all clumps in the Default
slot.
clump group 'outer'
Assign the group FrontLeft
to all clumps in the Default
slot. The \(x\)- and \(y\)- components of the clump centroids must fall within the specified ranges for the group to be applied.
clump group 'FrontLeft' range ...
position-x [lbx-0.05*dx] 0.0 position-y [lby-0.05*dy] 0.5
Remove the group outer
in all slots for all clumps.
clump group remove 'outer'
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |