rblock select
command
Syntax
- rblock select <keyword> <range>
-
This commands selects or de-selects all rigid blocks in the range. Selected objects can be specified in a range filter by using the selected keyword. Objects that are not selected can be specified in a range filter by using the deselected keyword.
The following keywords are available:
- b
If a boolean type is specified, then if on it selects all rigid blocks in the range. If off it de-selects all rigid blocks in the range. on is the default if no keyword is given.
- new
Implies on. This will select rigid blocks in the range, and automatically de-select rigid blocks not in the range.
- undo
This will reverse the operation of the last
rblock select
command. A maximum undo stack of size 12 is retained.
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |