rblock.euler
Syntax
- v = rblock.euler(p) (3D ONLY)
- rblock.euler(p) = v (3D ONLY)
Get/set the rigid block orientation. The convention {X,Y′,Z″} is used (i.e., the x-, y-, and z-components correspond to the sequential rotations about the X, Y′, and Z″ axes). This value is incremented during cycling, and can be reset.
Returns: v - rigid block orientation vector Accepts: v - rigid block orientation vector Arguments: p - rigid block pointer
Component Access
f = rblock.euler
(p)->x
rblock.euler
(p)->x
= f
- f = rblock.euler.x(p) (3D ONLY)
- rblock.euler.x(p) = f (3D ONLY)
Get/set the x-component of the rigid block orientation.
Returns: f - x-component of the rigid block orientation vector Accepts: f - x-component of the rigid block orientation vector Arguments: p - rigid block pointer
Access other vector components (y, z (3D ONLY)) by substituting the component name where x appears above. See Member Access Operator for information about accessing members from data types using ->
.
Deprecated Component Access
Component access by adding an optional integer in the function arguments (e.g., f = rblock.euler(p, 3)
) is deprecated. It remains available but will not be supported in future versions. See Component Access with Integers in FISH on the Deprecated Commands and FISH page for details.
Was this helpful? ... | FLAC3D © 2019, Itasca | Updated: Feb 25, 2024 |