program license command

Syntax

program license keyword

Primary keywords:

list    location    email    local    network

Get/Set license information.

Note

As with all program commands, use of the command word program is optional; program list and list are both valid.

The following keywords are available

list keyword

List license information. The following sub keywords are available.

claimed

List the currently claimed licenses.

diagnostics

Output a complete set of security and licensing diagnostics. This text is intended to be sent to Itasca to assist in supporting and diagnosing licensing issues.

key-information

Look for a valid Itasca security key directly connected to the computer and report all of the information on it. The key does not have to contain a valid license for this code, it may be for any Itasca code. Only one Itasca key can be directly connected to the computer for this operation.

requirements

List the license requirements based on the current model state.

security

Look for a valid license(s) (using the current location settings) and report the contents of the license(s) if found. The license information will be for the current license requirements, or if there are none it will use the minimum default requirements.

serial

List the serial number(s) of the licenses that meet the current license requirements. If there are no current requirments, it will use the minimum default requirements.

test

Perform tests of the licensing system and report the results.

location keyword

Specify the location used to obtain any licenses used the satisfy the current requirements. The following license location keywords are available:

email semail

Specify the email address used as the user account name for web licenses.

local bactive

Specify whether the local key license system is active or not.

network bactive

Specify whether the network key license system is active or not.

Indicates that the license(s) can be found on a network server that is directly connected to a SuperPro network hardware key. The server name must be indicated immediately following - this can be an ip address (as a string), the name of a computer on the local network, or a URL. If no server name is specified, then the system will use whatever server was last specified for a network key license. Use the string localhost to indicate the network key and server is the current computer. The optional key-id keyword can be used to specific a specific key be used by entering a key serial number.

server servername

Specify the name of the server that is used to find network key licenses. This can be either the name, url, or ip address of the server. Use the string localhost to indicate the server is the current computer.

password spassword

Specify the web license password associated with the user account. Note this password is stored in an encrypted form.

web bactive

Specify whether the web licenses system is active or not.