structure link slide-tolerance
command
Syntax
- structure link tolerance-slide f <range>
Set the tolerance used when updating node-to-zone links in response to large-strain motion. A node is considered to be in a zone if it is within a distance \(\delta\) of the zone boundary, where \(\delta\) equals f times zone size (taken as the maximum \(x\)-, \(y\)-, or \(z\)-dimension of the zone bounding box). By default, f equals 1 × 10-5.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Oct 14, 2024 |