`zone.field.tol`

Syntax

- f := zone.field.tol() (3D ONLY)
- zone.field.tol() = f
Get/set the tolerance used for the polynomial method of extrapolation. The default is 1e-7.

This value is used to detect a degeneracy in the matrix used to solve for polynomial extrapolation coefficients. If a degeneracy is detected, the matrix is revised to assume there is no change in that degree-of-freedom.

- Returns:
f - the tolerance used for polynomial method of extrapolation

- Accepts:
f - the tolerance used for polynomial method of extrapolation

Was this helpful? ... | Itasca Software © 2023, Itasca | Updated: Nov 30, 2023 |