rblock hide command
Syntax
- rblock hide <keyword> <range>
Primary keywords:
This command hides or un-hides all rigid blocks in the range. By default, commands that use a range filter will skip hidden objects. This can be overruled with the use-hidden keyword in the range specification.
The following keywords are available:
- b
If a boolean type is specified, then if on it hides all rigid blocks in the range. If off it un-hides (or shows) all rigid blocks in the range, and the use-hidden keyword is applied to the range implicitly. on is the default if no keyword is given.
- undo
This will reverse the operation of the last
rblock hidecommand. A maximum undo stack of size 12 is retained.
| Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Oct 31, 2024 |
