contact group
command
Syntax
- contact group s keyword ... <range>
Primary keywords:
Specify contact group names. Use of the group logic is described in Groups. By default, s is assigned to the group slot Default. Use the any keyword to assign the group name to the next available slot and the remove keyword to remove s from all slots.
By default, only mechanical contacts are considered.
- add
Assign s to the next available slot.
- mechanical
Apply to mechanical contacts.
- remove
Remove s from all slots.
- thermal
Apply to thermal contacts.
Usage Example
contact group 'Lining' range cylinder end-1 (16.0,-6.0,6.0) ...
end-2 (16.0,6.0,6.0) radius 4.0
from “lining.dat” in Shallow Foundation
contact group 'glued' range plane dip 90 dip-direction 90 ...
origin -6.5 0.5 24.5 dist 0.01 position-z 15 100
contact group 'glued' range plane dip 90 dip-direction 90 ...
origin 6.5 0.5 24.5 dist 0.01 position-z 15 100
contact group 'glued' range plane dip 90 dip-direction 90 ...
origin -18.7 0.5 16.6 dist 0.01 position-z 15 100
contact group 'glued' range plane dip 90 dip-direction 90 ...
origin 18.7 0.5 16.6 dist 0.01 position-z 15 100
from “buttress.dat” in Rigid Block Model of Flying Buttresses
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |