The Cycling Dialog
When the program cycles, the Cycling dialog is shown.
![../../../../../../../_images/cyclingdialogunembedded.png](../../../../../../../_images/cyclingdialogunembedded.png)
Pressing ) may be clicked to un-embed the dialog as desired.
![../../../../../../../_images/cyclingdialogembedded.png](../../../../../../../_images/cyclingdialogembedded.png)
The elements reported in the dialog are as follows.
- Determinism:
Indicates whether determinism is “on” or “off” for these calculations. The adjacent “Help” button (
) may be used to go to the topic in this documentation describing the use of the determinism setting.
- Threads:
Indicates the number of threads in use.
- Update Interval:
Indicates the number of steps between plot updates.
Continuously Updated Table Elements
- Cycle
Reports the current cycle.
- Total
Reports the total number of cycles.
- Timestep
Reports the size of the current timestep.
- Clock
Reports the time elapsed since cycling commenced.
- Limit
Indicates the cycle limit applied by the command that started the current cycling, if given.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |