building-blocks block list
command
Syntax
- building-blocks block list keyword <range>
-
Print information about blocks. If <
range
> is not supplied, the requested information is listed for all blocks in the current building blocks set.- edges
Edge IDs for each block are listed.
- faces
Face IDs for each block are listed.
- group
Group information is listed.
- information
Comprehensive information is listed, including groups, extras, degeneracy, and zone multiplier.
- nodes
Node IDs for each block are listed.
- points
List point information.
- status
Validation status for each block is listed.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |