building-blocks edge add-controls
command
Syntax
- building-blocks edge add-controls keyword <range>
Add control points to edges. Control points are added on all edges in the current building blocks set if <
range
> is not supplied.- i
Add exactly i control points per each edge (i must be a positive integer no greater than 20). Added control points will be evenly spaced.
- use-size
Add a number of control points equal to the number of zones on each edge (see
building-blocks edge size
).
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |