building-blocks point move-to
command
Syntax
- building-blocks point move-to keyword f <control-point b > <range>
Move points. Position components (\(x\), \(y\), or \(z\)) of points in the <
range
>, if supplied, are moved to the value f; all points are moved if no range is supplied.The <control-point b> option for the edges with control points indicates whether control-points on an edge should move if only one of the points of that edge is moved. For the faces with control points the option indicates where control-points of a face should move if not all of the face points are moved. The default is true.
- x
Set the \(x\)-component of the point(s).
- y
Set the \(y\)-component of the point(s).
- z
Set the \(z\)-component of the point(s).
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |