building-blocks set import
command
Syntax
- building-blocks set import keyword
Import a building blocks set.
- s1 <set s2 > <v >
Import blocks from the file s1. The file must have one of the extensions “.f3bset”, “.f3grid” or “.flac3d” (and be a valid file of that type). The destination building blocks set is s2. If s2 is not supplied a new set is created and given a set name that derives from the file name s1. When <v> is supplied the coordinates of all the points of imported blocks will be shifted by that vector.
- sketch <to-set s > <v >
Import building blocks from the current set in the Sketch Pane. If the to-set s option is used, the destination will be the building blocks set with the name s. If not, the destination will be the current building blocks set. When <v> is supplied the coordinates of all the points of imported blocks will be shifted by that vector.
Note
If a set with the same name as the imported set exists already, it will be deleted and replaced.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |