ratio
command
Syntax
- sketch edge ratio f keyword <range>
Primary keywords:
Set the ratio. The value f (a number between 0.1 and 10.1) is used to distribute zone lengths along the edge (each zone will be f of the size of the zone preceding it). This setting automatically propagates across dependent edges of regular blocks while
Ratio-Isolate
is false.If <
range
> is not supplied, the command operates on all edges in the set.- automatic
When this keyword is specified, the ratio is automatically adjusted so zones are densified towards the end that connects to an edge with smallest zones/discretization (among all conneceted edges).
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |