automatic-zone
command
Syntax
- sketch set automatic-zone keyword
-
Set automatic zoning of the sketch set.
- direction keyword (3D only)
Control which part(s) of the extrusion are auto-zoned. If not specified, the last value specified is retained (the default is
both
). In FLAC2D automatic zoning is restricted to theconstruction
setting; this keyword is not used.- both
Auto-zoning is applied to both the 2D construction data, and the 1D extrude segment data. This is the default.
- construction
Auto-zoning is applied to the 2D construction data only.
- extrusion
Auto-zoning is applied to the extrude segment data only.
- edge f
Auto-zoning will attempt to keep the average length of a zone edge to the value f. If not supplied, the previous value will be used. The default value is 1.0.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |