sketch.set.badzones
Syntax
- b := sketch.set.badzones(sp<,bi>)
Check whether or not any elements in the set have bad geometries based on the sketch criteria (the check is performed for quadrilateral elements only). The function will return true if the set contains at least one bad quadrilateral element which, if generated into zones, may result in the “bad geometry” error. The function checks for the two most severe problems with 2D quadrilateral elements (in the Sketch pane): an element is not convex or if the area of a triangular sub-element in each overlay \(\le\) 10% of the whole element area.
See also
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |