sketch.set.zone.autodir
Syntax
- i := sketch.set.zone.autodir(sp)
- sketch.set.zone.target.autodir(sp) := i
The function only applies to 3D case (when 3D zones are generated from the sketch).
Get/set the flag for auto-zoning direction. Possible return/assignment values are: 0 = all (both directions); 1 = x,y (construction direction); 2 - normal (extrusion direction).
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |