rblock apply-facet-groups
command
Syntax
- rblock apply-facet-groups <keyword> <range>
-
Apply facet groups to contacts. The rigid block list is traversed in order, and contacts are inspected per rigid block in range.
A facet group is applied to a contact if the angle between the facet and the contact normal is less than the value provided by the tolerance keyword.
The facet with closest point to the contact position with normal as described above is selected. By default the tolerance is 0 degrees.
Usage Examples
Apply facet groups to all contacts, using default tolerance (0 degrees).
rblock apply-facet-groups
from “contacts.dat” in Using the Rigid Body Spring Network Paradigm
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |