rblock reflect
command
Syntax
- rblock reflect keyword ... <range>
Primary keywords:
All rigid blocks within the given range are reflected across the plane. Note that group information is copied.
The following keywords are available to control how this reflection is accomplished.
- dip-direction f (3D ONLY)
Specify the dip direction f [degrees] of the plane measured in the global \(xy\)-plane clockwise from the positive \(y\)-axis. (The default is f = 0.)
- dip f
Specify (in PFC3D) the dip angle f [degrees] of the plane, measured in the negative \(z\)-direction from the global \(xy\)-plane. (The default is f = 0.)
In PFC2D, this specifies the angle f [degrees] of the plane measured clockwise from the global \(x\)-axis. (The default is f = 0.)
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |