rblock thermal attribute
command
Syntax
- rblock thermal attribute keyword ... <range>
Primary keywords:
expansion power-applied specific-heat temperature temperature-increment
Set the value of rigid block thermal attributes. This command is a synonym for the
rblock thermal initialize
command. Individual attributes can be listed with therblock thermal list
command, and all rigid block thermal attributes can be visualized.Note
Similar to rigid block attributes and properties, there is a fundamental distinction between rigid block thermal attributes and rigid block thermal properties. Rigid block thermal attributes are characteristics of the thermal rigid blocks, such as temperature or power.
- expansion f [rbtmodblock]
thermal-expansion coefficient
- power-applied f [rbtmodblock]
applied power
- specific-heat f [rbtmodblock]
specific heat
- temperature f [rbtmodblock]
temperature
- temperature-increment f [rbtmodblock]
temperature increment since last mechanical coupling
rblock thermal attribute
Keyword Block
The following keywords may be used to modify the base value supplied. expansion
, power-applied
, specific-heat
, temperature
and temperature-increment
.
- gradient v
Apply a linear gradient in each of the axes directions starting at the origin.
- gradient-x f
Apply a linear gradient in the \(x\)-direction starting at the origin.
- gradient-y f
Apply a linear gradient in the \(y\)-direction starting at the origin.
- gradient-z f (3D ONLY)
Apply a linear gradient in the \(z\)-direction starting at the origin.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 13, 2024 |