geometry edge group command

Syntax

geometry edge group s <keyword ...> <range>

Primary keywords:

remove    set    slot

Assign the group s to the edges of the geometric set that fall within the range. Use of the group logic is described in Groups. This command may take the form geometry edge group "slotname = groupname" — quotation marks required, spaces at equals sign ignored — where slotname is the slot assignment and groupname is the group name. If the set keyword is not given, then the current set is used.

remove

Remove s from all edges. If no slot was specified, then the group will be removed from all slots it is found in.

set s

Specify the geometry set.

slot slot

Set group slot slot to s. By default, slot Default is used.