geometry separate command
Syntax
- geometry separate keyword ... <range>
Primary keywords:
Separate polygons into sets. Individual sets are created out of each group of polygons that fit the desired separation criteria. For instance, a geometry set containing two polygons are split into two separate geometry sets. The geometry set names will be s with an integer count appended (e.g., if s = fred, then one set will be named fred1 and the other will be fred2). If the set keyword is not given, then the current set is used.
The following separation criteria are supported:
- by-closed-volume
Attempts to separate polygons into collections that form closed watertight volumes.
- by-connected
Separates polygons into collections that are connected across edges.
- by-group
Separates polygons into collections sharing the same group name. Note that polygons may end up in multiple sets if they share group names in multiple slots.
- name s
Name of output geometry sets. If not given they will start with the name of the geometry set that is separated.
- set s
Specify the geometry set to separate.
| Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Dec 19, 2024 |
