model configure command

Syntax

model configure keyword ...

Configure an additional calculation mode.

This command allows the user to specify that the model is using calculation modes that either require extra resources or are restricted by the current license.

The model.configure command can be given at any stage of an analysis, but it must be given before the calculation mode (model solve or model cycle) can be invoked.

The following keywords apply.

array f

Specify the amount of memory to be used by 3DEC in MB. The default is 2000.

axisymmetry

FLAC2D axisymmetric analysis. Currently available for standard mechanical analysis only (no full dynamics).

cfd

PFC CFD analysis

creep

Creep material analysis*

dynamic

Fully dynamic analysis*

energy

Energy tracking in 3DEC

feblock

Finite element blocks in 3DEC

fluid-flow

Fluid-flow analysis

highorder

Include higher-order tetrahedra in the model (must be given before blocks are created in 3DEC).

hotetra

Include higher-order tetrahedra in the model (must be given before blocks are created in 3DEC).

imass

The Itasca Model for Advanced Strain Softening*

matrixflow

Matrix flow in 3DEC

thermal

Thermal analysis

Note

*These analysis modes are available only if the corresponding program option is included in the program license.