structure node join
command
Syntax
- structure node join <keyword> <range>
Primary keywords:
Create node-to-node links on all nodes in the range by attempting to find another node in the range that is at the same position. If found, and if the node does not already possess a node-to-node link, then any existing link is deleted and a new node-to-node link is created. The source node is rigidly attached in all six degrees-of-freedom to the target node. Any links that exist on the target node are not modified.
The following keywords are available to modify the link-creation process:
- group s <slot slot >
Specify a group assignment that will be made to all links created with this command. The slot keyword can be used to specify the slot used, otherwise the slot will be Default. Use of the group logic is described in Groups.
- range-target range
Specify a range (as with the <range> phrase) that is used to select target nodes. Target nodes must fall within this range to be considered. Note that both a range-target and a range may be given at the same time.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Dec 05, 2024 |