attach.type
Syntax
- i := attach.type(a)
Note
- In the description below, the following correspondence is assumed between 3D and 2D analysis:
3D volumes <-> 2D areas
There is no 2D equivalence for 3D zone edges
3D zone faces (surfaces) <-> 2D zone edges (lines)
Returns the attachment type.
- For FLAC2D:
Returns 1, indicating that the attachment is attached to a gridpoint Returns 2, indicating that the attachment is attached to a face
- For FLAC3D:
Returns 1, indicating that the attachment is attached to a gridpoint Returns 2, indicating that the attachment is attached to an edge Returns 3, indicating that the attachment is attached to a face
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Dec 05, 2024 |