massflow marker size-distribution
command
Syntax
- massflow marker size-distribution <keyword>
Make a table of cumulative number of extracted markers (0-100%) versus fragment diameter. The x-axis is usually plotted on a log scale.
- divisions i
- Specify the number of bins when creating the histogram (i.e. the number of divisions on the x-axis). The bins are then calculated to give an even spacing of fragment diameters assuming a log scale.
If this input is omitted, 50 divisions are used.
- drawpoints i1 <i2 ...>
- List one or more drawpoint IDs to limit the size distribution curve to consider only those fragments extracted from the specified drawpoints.
If this input is omitted, all drawpoints will be considered.
- minimum f
- Specify the minimum fragment size to be used when creating the histogram (i.e. the minimum value on the x-axis).
If this input is omitted, the minimum fragment diameter is used.
- maximum f
- Specify the maximum fragment size to be used when creating the histogram (i.e. the maximum value on the x-axis).
If this input is omitted, the maximum fragment diameter is used.
- period-start i
Specify the starting period for extracted markers. Markers extracted before the input period are not considered. The default value is 1.
- period-end i
Specify the ending period for extracted markers. Markers extracted after the input period are not considered. The default value is the number of periods that have been calculated.
- table s
Specify the name of the table. If no name is given, the table name defaults to size-distribution.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Sep 26, 2024 |