massflow.mineblock.installmarkers
Syntax
- i = .mineblock.installmarkers(mb,i<,f>)
Manually install markers into mineblock mb. The marker type to be installed is given by i. The types are as follows:
-2: unbulked for IMZ growth
-1: unbulked for collapse
0: unbulked for rilling
1: partially bulked
2: fully bulked
3: air
Optionally, if air markers are being installed, the porosity can be specified as f (between 0 and 1). If no value is given, the default is 0.5.
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Aug 29, 2025 |