contact cmat proximity command
Syntax
- contact cmat <sprocess> proximity fd
The contact detection distance is set to fd. This ensures that contacts will be subsequently detected between pieces with a surface gap less than or equal to the specified value. Contacts may also be created between pieces further apart. Note that issuing this command does not automatically trigger a contact detection; instead contacts will be detected during subsequent cycles. Alternatively, the command
model clean
can be issued to force contact detection.By default, only mechanical contacts are considered. If sprocess is specified, then it must correspond to a process name and contacts within this process are considered.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |