contact group command

Syntax

contact <sprocess> group s keyword ... <range>

Primary keywords:

add    remove    slot

Specify contact group names. Use of the group logic is described in Group. By default, s is assigned to the group slot Default. Use the any keyword to assign the group name to the next available slot and the remove keyword to remove s from all slots.

By default, only mechanical contacts are considered. If sprocess is specified, then it must correspond to a process name and contacts within this process are considered.

add

Assign s to the next available slot.

remove

Remove s from all slots.

slot slot

Set group slot slot to s. By default, slot Default is used.