geometry edge export command
Syntax
- geometry edge export s <keyword> <range>
-
Export geometry edges data. Edges, as well as required nodes, are output to the file with name s. The default file type is the Itasca geometry format, and the range applies to edges. STL format does not have ability to store edges, should be not used here.
- binary
Indicate that the binary version of the file format should be used for export. This is not valid with DXF export.
- format keyword
Specifiy the file format to use for export. The default will be selected based on the file name extension.
- dxf
AutoCAD DXF format with file extension “.dxf.”
- geometry
Itasca geometry format with file extentsion “.geom.” This is the default format, and is described in Geometry Text File Format.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |