geometry edge group command
Syntax
- geometry edge group s <keyword> <range>
-
Assign the group s to the edges of the geometric set that fall within the range. Use of the group logic is described in Group. This command may take the form
geometry edge group
"slotname = groupname" — quotation marks required, spaces at equals sign ignored — where slotname is the slot assignment and groupname is the group name.- remove
Remove s from all edges. If no slot was specified, then the group will be removed from all slots it is found in.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |