model configure command

Syntax

model configure keyword ...

Configure an additional calculation mode. This command allows the user to specify that the model is using calculation modes that either require extra resources or are restricted by your license information. The model.configure command can be given at any stage of an analysis, but it must be given before the calculation mode (model solve or model cycle) can be invoked.

The following keywords apply.

cfd

CFD (computational fluid dynamics) analysis* (PFC3D only)

creep

Creep material analysis*

dynamic

Fully dynamic analysis*

fluid

Fluid-flow analysis

imass

The Itasca Model for Advanced Strain Softening*

plugin

C++ user-defined models and/or FISH intrinsic plugins.* FISH plugins can be loaded (but cycling is disabled) without this configuration.

thermal

Thermal analysis

Note

*These analysis modes are available only if the corresponding program option is included in the program license.