program log-file command
Syntax
- program log-file s <keyword>
Specify the log file by name.
Note
As with all program commands, use of the command word program is optional; program log-file and log-file are both valid.
Logging must be activated with the
program log
on command [DR: check previous commmand is correct] to activate writing. If logging is active and the program.log-file command is given, then the previous log file (if any) is closed and the new file s is opened.If the log file is opened, then the following keywords are available to control what happens to any existing file with that name.
- append
Information is added to the end of the log file. This is the default behavior.
- truncate
Any existing log file is cleared before new information is added.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |