- hydration-drucker-prager
- bulk-reference f
reference bulk modulus for α = 1, Kcte
- constant-a f
material parameter, a
- constant-c f
material parameter, c
- hydration-minimum f
minimum hydration grade, α0
- hydration-difference-minimum f
minimum difference of (α − α0)min
- poisson f
Poisson’s ratio, ν
- shear-reference f
reference shear modulus for α = 1, Gcte
- young-reference f
reference Young’s modulus for α = 1, Ecte
- tension-reference f
reference tensile strength for α = 1, fcte
- bulk f
[read only] bulk modulus, K
- cohesion-drucker f
[read only] Drucker-Prager material parameter, kφ
- compression f
[read only] compressive strength limit, σc
- dilation-drucker f
[read only] Drucker-Prager material parameter, qψ
- friction-drucker f
[read only] Drucker-Prager material parameter, qφ
- shear f
[read only] shear modulus, G
- tension f
[read only] tension cut-off, σt
- young f
[read only] Young’s modulus, E
Notes:
- Only one of the two options is required to define the elasticity: reference bulk modulus Kcte and reference shear modulus Gcte, or reference Young’s modulus Ecte and Poisson’s ratio v. When choosing the latter, reference Young’s modulus E must be assigned in advance of Poisson’s ratio v.
- The tension cut-off is σt = min (σt(α)/3.0, kϕ(α)/qϕ(α)).
Footnote
Read only properties cannot be set by the user. However, they may be listed, plotted, or accessed through FISH.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |