Sets of Blocks

When the Building Blocks pane opens, the toolbar will hold a list of all the existing sets of blocks in the project. The currently active set is the one selected in the list and displayed in the pane. A new set can be created using the tool button labeled “Add a new set…” ().

Each set of blocks can have its own sets of geometric data loaded for reference.

Importing and Exporting Sets

You can export a set through the File menu by choosing File —> Building Blocks —> Export —> Building Blocks Set.

You can import a set using File —> Open into Project (with file extension .f3bset). The imported set will become the current set. Sets you had previously loaded will still be available and are accessible from the list of sets in the toolbar.

Building blocks can be exported from the Extrusion pane into the Building Blocks pane. Once you have set up your model in the extruder, click the tool button to show the Extrusion View and then click the tool button labeled “Create building blocks” ().

You can import blocks from a saved set into the current set, leaving existing blocks in the current set intact. This is done with the Import Blocks tool button (). When you click the button, a dialog will appear with a list of building block sets for you to choose from. Or, you can click the menu button just to the right of the tool button for faster access to a set of blocks. In either case, once you choose to import blocks, a dialog will appear with options for placement of the blocks.

Figure 1: Dialog for importing blocks into a set.

Figure 2: Options for placement of imported blocks.

As figure 1 shows, the list of building block sets comes from a specific folder. You can add your own sets of blocks to that folder. You can also add an image file for display as a preview when a set is selected in the list. The image file needs to be of type PNG with a .png file extension, and must have the same base file name as the set of blocks. The image is expected to be 200x200 pixels in size.

After you choose which set of blocks to import, the dialog in figure 2 appears. You can position the center of the imported blocks at the center of the view, or place the center of the blocks at the origin (0, 0, 0), or offset the blocks from their original location.