building-blocks block create command
Syntax
- building-blocks block create keyword
Primary keywords:
Create a block or blocks.
- from-faces <distance f > range
Create blocks attached to the faces specified by the
range
. All faces here must be external faces — each face is attached to one block only. New blocks will be “extruded” from the faces along the average face normal. The extruded distance is defined by f. If f is not supplied the default distance will be related to the maximum diagonal extent of a block among all the blocks attached to supplied faces.
- hexahedron <by-points v1 v2 v3 v4 v5 v6 v7 v8 > <group s <slot s >>
Create a hexahedral block. by-points, if present, must be followed by points that define the block (a hexahedron requires eight points). The optional keywords group and slot assign the created block to the specified group and slot.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |