building-blocks edge list command
Syntax
- building-blocks edge list keyword <range>
Primary keywords:
Print information about edges. If <
range
> is not supplied, the requested information is listed for all edges in the current building blocks set.- group
Group information is listed.
- information
Comprehensive information is listed, including groups, extras, length of the edge, direction, zone size, zone ratio, type and number of control points.
- faces
IDs for each face connected to the edge(s) are listed.
- nodes
IDs for the nodes of the edge(s) are listed.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |