building-blocks set import command
Syntax
- building-blocks set import keyword
Import a building blocks set.
- extruder <to-set s > <v >
Import building blocks from the current set in the Extrusion Pane. If the to-set s option is used, the destination will be the building blocks set with the name s. If not, the destination will be the current building blocks set. When <v> is supplied the coordinates of all the points of imported blocks will be shifted by that vector.
- s1 <set s2> <:vec:v>
Import blocks from the file s1. The file must have one of the extensions “.f3bset”, “.f3grid” or “.flac3d” (and be a valid file of that type). The destination building blocks set is s2. If s2 is not supplied a new set is created and given a set name that derives from the file name s1. When <v> is supplied the coordinates of all the points of imported blocks will be shifted by that vector.
Note
If a set with the same name as the imported set exists already, it will be deleted and replaced.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |