id command
Syntax
- extrude edge id i <keyword>
Primary keywords:
Modify a single edge by ID.
- control-point keyword
- add <local> v <v ...>
Add one or more control points at locations v, 2D coordinate vector (\(x\),\(y\)). If local is used, then the locations are in a coordinate system defined by the edge, where \(x\) goes from end 1 at 0.0 to end 2 at 1.0, and \(y\) is normal to that.
- clear
Remove all control points.
- split v <block> <tolerance-merge f >
Split the edge at location v, a 2D coordinate vector (\(x\),\(y\)). If keyword block is included and the edge belongs to a regular block, the split is propagated across all connected regular blocks. If keyword “block” is not provided or the edge belongs to an irregular block, the command splits the edge and deletes the block. If supplied, tolerance-merge f will be used as the tolerance for merging points during splitting.
- group s1 <slot s2 > <remove>
Assign the group name s1 in slot s2 (if supplied) to the edge. The edge is removed from the group/slot if remove is present. The slot is Default if not supplied.
- ratio f
Set the ratio f (a number between 0.1 and 10.1), which is used to distribute zone lengths along the edge (each zone will be f of the size of the zone preceding it). This setting automatically propagates across dependent edges of regular blocks while Ratio-Isolate is false.
- ratio-isolate b
The option only applies to the edges which form regular (3- or 4-sided) blocks.
Set the flag to control ratio propagation. Ratio settings propagate when false (the default). If set true, a ratio assignment on this edge will not propagate to dependent edges.
- size i
Set the number of zones on the edge. This will also automatically propagate across dependent edges of regular blocks.
- type keyword
Specify the curve type of the edge.
- arc
- polyline
- simple
This is the default type (a line).
- spline
| Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |